Using The Pc-1271/1271M Signal Interface Switcher - Sony VPH-G90E Manuel D'installation

Using the PC-1271/1271M Signal Interface Switcher

Connecting the PC-1271/1271M using the SIC-M or CCQ-BRS connecting cable
IN OUT
TRIGGER LINK
VIDEO IN
to video output
Video
equipment
to S Video output
* For the VPH-G90E model: IFB-G90E Video Interface Board (optional)
38
(GB) Connections
When you install the optional IFB-40 Signal Interface Board to the
projector and connect the PC-1271/1271M Signal Interface Switcher to the
IFB-40, you can connect easily various input sources.
You can select the input to the switcher easily by pressing the
SWITCHER/VIDEO MEMORY/INDEX keys on the remote commander.
Rear
*
IN OUT
R G
IN OUT Y IN C IN
R-Y/P Y B-Y/P
R
VIDEO S VIDEO
VIDEO
IN OUT
RS-232C/422A IN
RS-232C RS-422A
PLUG IN POWER
CONTROL S DEVICE INDEX REMOTE
S VIDEO
IN
to RGB output
Computer
Choose the appropriate cable from the following table.
1 m 2 m
— CCQ-2BRS CCQ-5BRS CCQ-10BRS —
SIC-M-1 —
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable
correctly.
• You can extend the SIC-M or CCQ-BRS cable up to 50 m.
• The video signal input to the IFB-40 installed to the INPUT B section
should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors
using the 5BNC cables.
Setting up
• Set INPUT-A in the SET SETTING 1 menu
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote commander.
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
AC IN
AC power cord (supplied)
B SYNC/HD VD
B
REMOTE1
INPUT A
IN
PJ COM OUT
INPUT A
SIC-M or CCQ-BRS
connecting cable
to REMOTE 1 OUT
PC-1271/1271M
Switcher
5 m 10 m
SIC-M-5 —
to a wall outlet
MODE
IFB-40 Signal
Interface Board
OUT
(optional)
IN
Video
equipment
Signal flow
15 m 25 m 50 m
CCQ-25BRS CCQ-50BRS
SIC-M-15 SIC-M-25 SIC-M-50
to RGB.
(on page 62 )
(GB)