Input Memory - Sony VPH-G90E Manuel D'installation

Input Memory

Contents of input memory
Identification data for the input signal
Original Input Memory (No. 00 – 12)
The 150 input memory of this projector is divided into two.
Either input memory stores the same data contents.
• Original Input Memory No. 00 – 12
• Custom Input Memory No. 13 – 149
Each input memory consists of the following data.
• Identification data for the input signal
• Set/adjusted data (registration, magnetic focus, CUSTOM data of white
balance)
• Data of video memory OFF
The projector judges the input signal using the following identification
data, and searches for and selects the appropriate input memory for the
input signal.
Item
Input channel
Input channel selected when the input memory is
(Custom Memory only)
registered to a new number
VIDEO, INPUT-A, INPUT-B, INPUT-C, SWITCHER 1–
1 to 8–8
Input signal type
Type of the input signal when the input memory is
(Original and Custom
registered to a new number
Memory)
VIDEO, S VIDEO, COMPONENT, RGB, 15 k RGB,
HDTV-YPBPR, HDTV-GBR, SDI 4:2:2, DRC, IDTV,
etc.
Type of the sync signal used when the input memory is
Sync signal type
registered to a new number
(Custom Memory only)
H/C: P/N/–, V: P/N/–, SonG: N/–
P (positive), N (negative), – (no sync)
fH (horizontal frequency), fV (vertical frequency),
Input frequency
scanning lines
(Original and Custom
Memory)
The Original Input Memory stores the data set/adjusted at the factory.
When a new type of signal is input, no signal is input or the internally
generated signal is used, the projector loads the data of the Original Input
Memory.
Data
(continued)
133
Adjustments (GB)