Sony VPH-G90E Manuel D'installation page 39

Connecting the PC-1271/1271M using both the SIC-M or CCQ-BRS connecting cable and
the 5BNC cables (5BNC mode 1)
*
IN
IN OUT
VIDEO
TRIGGER LINK
IN
PLUG IN POWER
CONTROL S
VIDEO IN
to video output
Video
equipment
to S Video
output
* For the VPH-G90E model:
IFB-G90E Video Interface Board (optional)
When you connect both the video and RGB signal input sources to the PC-
1271/1271M switcher, use the SIC-M or CCQ-BRS connecting cable and
the BNC cables for connection between the projector and switcher.
Rear
IN OUT R G B SYNC/HD
OUT Y IN C IN
R-Y/P Y B-Y/P
R B
S VIDEO
VIDEO INPUT A
OUT
RS-232C/422A IN PJ COM
RS-232C RS-422A
DEVICE INDEX REMOTE
S VIDEO
IN
5BNC cables
to MONITOR OUT
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable
correctly.
• You can extend the SIC-M or CCQ-BRS cable up to 50 m.
• The video signal input to the signal interface board IFB-40 installed to
the INPUT B section should not exceed 70 MHz. When projecting the
video signal which exceeds 70 MHz, connect the signal source to the
INPUT A connectors using the 5BNC cables.
AC IN
AC power cord (supplied)
to a wall outlet
VD
REMOTE1
IN
OUT
INPUT A IN
SIC-M or CCQ-BRS
connecting cable
to REMOTE 1 OUT
PC-1271/1271M
Switcher
HDTV/
Video
Component
equipment
equipment
MODE
IFB-40 Signal
Interface Board
OUT
(optional)
Computer Computer
Signal flow
(continued)
Connections
39
(GB)