Sony VPH-G90E Manuel D'installation page 34

Using the PC-3000 Signal Interface Switcher
34
(GB) Connections
Setting up
• Set the device index number of the projector to "01"
• Set the switcher number of the switcher which is connected directly to the
projector to "1," and that of the second switcher to "2," and so on.
For details, refer to the Operating Instructions of the switcher.
• When using the remote commander as a wireless remote control, activate
the remote control detector of a piece of the equipment in the system only
and deactivate those of the other equipment. Perform the setting on the
projector using "SIRCS RECEIVER" in the SET SETTING 2 menu
.
64 )
(GB)
For setting on the switcher, refer to the Operating Instructions of the switcher.
(page 142 ).
(GB)
(page