Sony VPH-G90E Manuel D'installation page 36

Using the PC-3000 Signal Interface Switcher
36
(GB) Connections
Notes
• Be sure to terminate the PJ COM IN or OUT connector not in use by
attaching the supplied terminator.
• The signal from the second switcher should be input to the first switcher
via the IFB-12/12A signal interface board installed to slot 1 of the first
switcher.
For details, refer to the Operating Instructions of the switcher.
Setting up
• Set the IN/OUT selector on the IFB-12/12A to OUT (output). The signal
input to INPUT A is output from the IFB-12/12A.
• Set the device index number of the first projector which is connected
directly to the video equipment or computer to "01," and the second
projector to "02."
(page 142
For details, refer to the Operating Instructions of the switcher.
• Set the switcher number of the switcher which is connected directly to the
projector to "1," and that of the second switcher to "2," and so on.
For details, refer to the Operating Instructions of the switcher.
• When using the remote commander as a wireless remote control, activate
the remote control detector of a piece of the equipment in the system only
and deactivate those of the other equipment. Perform the setting on the
projector using "SIRCS RECEIVER" in the SET SETTING 2 menu
.
(page 64 )
(GB)
For setting on the switcher, refer to the Operating Instructions of the switcher.
.
)
(GB)