Sony VPH-G90E Manuel D'installation page 144

Setting the Index Numbers
List of the Projection Distance by Angle of Optical Axis
To select the projector by designating the index numbers
PC-3000
Signal flow
PC-3000
Signal flow
Projector A
Signal flow
Projector B
Group index 1
144
(GB) Others
When the switchers and projectors are connected as illustrated, select the
desired projector by pressing the keys on the remote commander as shown
below.
Number 2 switcher
*
Number 1 switcher
*
Device index 01
*
Device index 02
* PJ COM IN/OUT connections
Example:
To select all the projectors
GROUP n ALL n ENTER n ALL n ENTER
Projectors A, B, C and D are selected.
To select projectors with device index 01 from all the groups
GROUP n ALL n ENTER n 1 n ENTER
Projectors A and C are selected.
To select a projector with device index 01 from group index 2
GROUP n 2 n ENTER n 1 n ENTER
Projector C is selected.
To select all the projectors from group index 2
GROUP n 2 n ENTER n ALL n ENTER
Projectors C and D are selected.
Notes
• Set the group index and device index numbers correctly. If more than two
projectors are set to the same group index and device index numbers, an
error message will be displayed when the SYS SET key is pressed.
• If the group index is a tens digit number, press the GROUP key before
each press of the number key.
Example:
To select a projector with device index 13 of group index 12
GROUP n 1 n GROUP n 2 n ENTER n 1 n 3 n ENTER
*
PC-3000
Signal flow
PC-3000
Signal flow
Projector C
Signal flow
Projector D
Group index 2
Number 2 switcher
*
Number 1 switcher
*
Device index 01
*
Device index 02