Safety Information - HYDAC ELECTRONIC HAT 1425 Notice D'utilisation

8

2.8 Safety Information

WARNING !
E
CAUTION !
Edition: 2021-02-22
 Destruction, damage or malfunctions of the measuring system !
Wiring work or opening and closing electrical connections must be
-
carried out in de-energised condition only.
Do not carry out welding if the measuring system has already been
-
wired up or is switched on.
Ensure that the area around the assembly site is protected from
-
corrosive fluids (acid, etc.).
Avoid any shocks (e.g. hammer-blow) on the measuring system
-
while mounting.
Do not bend the sensor rod
-
Do not install the measuring system next to magnetic fields.
-
Do not open the measuring system.
-
The measuring system contains electrostatically endangered circuit
elements and units which can be destroyed by improper use.
Touching the measuring system connection contacts with bare fingers
must be avoided, resp. the appropriate ESD protective measures are
applicable.
 Waste disposal
If disposal has to be undertaken at the end of a device's lifespan, the
respective applicable country-specific regulations must be taken into
consideration.
 Device designs
The technical details for customer-specific device designs, including
connection technology, may differ from the designs described here and in
the interface-specific user manuals.
The technical details for customer-specific device designs, including
connection technology, may differ from the designs described here and in
the interface-specific user manuals. In case of doubt, the manufacturer
should be consulted, specifying the item number.
HYDAC ELECTRONIC GMBH
HAT 1425 CANopen Safety
Part No.: 670047