Publicité
Les langues disponibles
Les langues disponibles
EN
Replicating the existing edge angle
1. Color the bevel with the
EM-15 Edge Marker so that you
can see where sharpening will
occur.
4. Raise the Universal Support with the Micro Adjust until the
whole bevel touches the grinding wheel. Check by moving the
grinding wheel by hand to see where sharpening will take place.
You have reached the correct sharpening angle when the ink from
the marker is worn off from the entire bevel.
Setting a new edge angle and measuring an edge angle
1. Set the diameter of the
grinding wheel on your WM-
200 AngleMaster.
6
2. Choose which of the two
stops you want to use. For taller
knives, use the bottom stop.
2. Set the desired edge angle
on the AngleMaster. Adjust
the Universal Support so that
the bevel is in contact with the
angle setter.
3. Adjust and lock the Universal
Support so that the heel of
the bevel touches the grinding
wheel.
3. You can measure the edge
angle in the grooves of the
AngleMaster, provided that the
bevels are wide enough.
Publicité
