tormek KJ-45 Instructions page 11

KJ-140 Wide Centering Knife Jig
Positioning of Machine
Sharpening direction: Edge leading or edge trailing.
Design
The KJ-140 Wide Centering Knife Jig comprises an ad-
justable clamp (1) for holding knives of varying thickness
and blade geometry, and two fixed stops (2) for sharpening
blades of different heights. The jig is adjusted to the knife
thickness with the screw (3). The knife is screwed into the
clamp with the knob (4) and locked centered in the jig.
The KJ-140 Wide Centering Knife Jig is designed to stabilize knives with flexible blades longer
than 160 mm, for even and controlled sharpening. It works in the same way as the KJ-45
Centering Knife Jig, but with a wider clamp that gives more support to flexible knife blades.
Follow the instructions on pages 4-10 for installation and use instructions. Please note
that the KJ-140 Wide Centering Knife Jig does not work with the SVM-00 Small Knife Holder.
LONG, FLEXIBLE KNIVES
E.g. filleting knives. Minimum blade length
(a) 160 mm.
140 mm
EN
11