Connection To The Mains Network; Cleaning Preserving Agent When Starting-Up Of Operation Initially - WAGNER TempSpray-H126 Mode D'emploi

TempSpray-H326 / -H226 / -H126/ -H426
4.2
TeMPSPray-H126 uND TeMPSPray-H426
1. Mount the governor housing (1) to the hose connector of
the airless-unit, thereby arrange the housing in a way that
you can reach the control panel easily and no important
accesses are barred.
2. Roll up the high-pressure hose.
3. Mount spray gun (2) to the high-pressure hose.
4. Tighten all coupling nuts well, in order that no coating
material can leak.
5. Mount the nozzle holder with the chosen nozzle on the
spray gun, position it and tighten it well (See manual of
the spray gun/ nozzle holder).
Counter with a wrench, if you unscrew the
high-pressure hose from the hose connector.
4.2.1
Before connecting the unit to the mains supply, ensure that
the line voltage matches that specified on the unit's rating
plate.
4.2.2
Rinse the heating hose with a suitable cleaning agent (recom-
mendation: water) at a low pressure setting. Therefore use a
spray gun without nozzle and spray into an open box.
1

cONNecTiON TO THe MaiNS NeTWOrk

Connection must always be carried out via
an appropriately grounded safety outlet with
residual-current-operated circuit-breaker.
cLeaNiNG PreSerViNG aGeNT WHeN
STarTiNG-uP OF OPeraTiON iNiTiaLLy
GB
startup
2
39