Panasonic AW-HE870E Instructions D'opération page 36

System configuration (Connections)
wConnection of the Outdoor Pan-tilt Head AW-PH650 (continued)
When an SDI card (AW-HHD870) has been installed
p Use a coaxial cable to connect the SDI OUT connector on the SDI card and the SDI IN connector on the AW-PH650 main
unit.
p Use a coaxial cable to connect the coaxial connector (SDI OUT) on the AW-PH650 to the SDI input connector on the colour
monitor.
Notes
p When transmitting HD (1080i or 720p) analogue component signals, set SW2 and SW3 on the COMP circuit board to the
HD position. The cable compensation circuit will not be activated even if SW1 is set to ON at this time so use this switch
at the OFF setting.
p For the connections inside the housing and other details, refer to the operating instructions of the AW-PH650.
p AW-IF400 Switch settings (when the AW-RP400 is used)
SW1 SW2
1
OFF ON OFF
SET UP
2 3 4
ON OFF OFF
- 35 (E) -