Panasonic AW-HE870E Instructions D'opération page 21

Mounting
p Example of mounting the camera onto a bracket
or tripod made by another manufacturer
Mounting screw for wire
(Inch screw: 1/4-20UNC) (supplied)
Drop-prevention wire (sold separately)
Spring washer (supplied)
Flat washer (supplied)
Camera mounting screw holes
Bracket or tripod made by another
manufacturer [*]
Flat washers [*]
Spring washers [*]
Mounting screws [*]
(Inch screws: 1/4-20UNC)
Notes
p When installing the mounting bracket or attaching one end of the
drop-prevention wire to the ceiling or a wall, be absolutely sure to
use the anchor bolts, and ensure that the withdrawal strength of the
installation surface is at least ten times the total mass of all units
installed, including the mounting bracket, camera, lens, and cables.
p When the camera has been attached to a tripod as well, be
absolutely sure to prevent the camera from falling off by using the
screw in the tripod or other such means.
p When mounting the camera on a surface above the camera, do not
block the ventilation holes of the cooling fan.
p Ensure that the total mass, including the mounting bracket, camera,
lens and cables, does not exceed 8 kg.
The connection and installation should be done by qualified service personnel
or system installers. Refer any servicing to qualified service personnel.
Secure the end of the wire onto the
M6 anchor bolts by tightening nut or
secure it by tightening the M6 bolts.
[*]: Procured locally
- 20 (E) -
p Example of mounting on a surface above the
camera
Mounting screws [*]
(Inch screws: 1/4-20UNC)
Spring washers [*]
Flat washers [*]
[*]: Procured locally
p Ensure that a drop-prevention wire is installed in such a way that the
drop distance does not exceed 150 mm.
p Tighten the mounting screws using the torque levels shown in the
table to the below, and then check for play and unsteadiness.
Screws
Mounting screws (Inch screws)
p Do not use an impact driver as doing so may cause damage to the
screws.
Adjust the camera mounting bracket
on the surface above the camera
so that the ventilation holes of the
cooling fan will not be blocked.
Camera mounting bracket [*]
Drop-prevention wire (sold separately)
Secure the end of the wire onto the
M6 anchor bolts by tightening nut or
secure it by tightening the M6 bolts.
Flat washer (supplied)
Spring washer (supplied)
Mounting screw for wire
(Inch screw: 1/4-20UNC) (supplied)
Clamping torque
2.0 N • m (20 kgf • cm)