Panasonic AW-HE870E Instructions D'opération page 12

Precautions for installation
Concerning the mounting screws and
drop-prevention wire
Attach the drop-prevention wire as a way to prevent the
camera from dropping.
p When the unit is to be mounted onto a Panasonic pan-tilt
head, use the mounting screws and drop-prevention wire
that are supplied with the pan-tilt head.
p When the unit is to be mounted onto a surface other than
a pan-tilt head, provide your own drop-prevention wire
and camera mounting bracket.
For details of the parts to be provided, refer to the next
page.
p Attach the drop-prevention wire to the camera mounting
screw hole (Inch screw).
The connection and installation should be done by
qualified service personnel or system installers.
Refer any servicing to qualified service personnel.
Tightening the mounting screws
Tighten using the torque levels shown in the table below.
After tightening, check for play and unsteadiness.
Screws
Mounting screws (Inch screws)
- 11 (E) -
Mounting screw for wire (supplied)
(Inch screw: 1/4-20UNC)
Spring washer (supplied)
Flat washer (supplied)
Drop-prevention wire
Pan-tilt head or
camera mounting bracket
Flat washers
Spring washers
Mounting screws
(Inch screws: 1/4-20UNC)
Clamping torque
2.0 N • m (20 kgf • cm)