Stihl MS 260 Notice D'emploi page 45

Definitions
1 Carburetor Box Cover Twist Lock
Lock for carburetor box cover.
2 Spark Plug Boot
Connects the spark plug with the
ignition lead.
3 Carburetor Adjusting Screws
For fine tuning the carburetor.
4 Handle Heating Switch
For switching the electric handle
heating on and off.
5 Chain Sprocket Cover
Covers the clutch and chain
sprocket.
6 Chain Sprocket
The toothed wheel that drives the
saw chain.
7 Chain Brake
A device to stop the rotation of the
chain. Is activated in a kickback
situation by the operator's hand or
by inertia.
8 Adjusting Wheel for Quick Chain
Tensioner
Permits precise adjustment of chain
tension.
9 Side Chain Tensioner
Permits precise adjustment of chain
tension.
10 Chain Catcher
Helps to reduce the risk of operator
contact by a chain when it breaks or
comes off the bar.
11 Bumper Spike
Toothed stop for holding saw steady
against wood.
MS 260, MS 260 C
12 Guide Bar
Supports and guides the saw chain.
13 Oilomatic Saw Chain
A loop consisting of cutters, tie
straps and drive links.
14 Oil Filler Cap
For closing the oil tank.
15 Muffler with Spark Arresting
Screen
Muffler reduces engine exhaust
noise and diverts exhaust gases
away from operator.
Spark arresting screen is designed
to reduce the risk of fire.
16 Front Hand Guard
Provides protection against
projecting branches and helps
prevent left hand from touching the
chain if it slips off the handlebar. It
also serves as the lever for chain
brake activation.
17 Front Handle
Handlebar for the left hand at the
front of the saw.
18 Decompression Valve –
(Automatically Resetting)
Releases compression pressure to
make starting easier – when
activated.
19 Starter Grip
The grip of the pull starter, for
starting the engine.
20 Fuel Filler Cap
For closing the fuel tank.
21 Master Control Lever
Lever for choke control, starting
throttle, run and stop switch
position.
22 Throttle Trigger
Controls the speed of the engine.
23 Throttle Trigger Lockout
Must be depressed before the
throttle trigger can be activated.
24 Rear Handle
The support handle for the right
hand, located at the rear of the saw.
25 Rear Hand Guard
Gives added protection to
operator's right hand.
Guide Bar Nose
The exposed end of the guide bar.
(not illustrated, see chapter
"Tensioning the Saw Chain")
Clutch
Couples engine to chain sprocket
when engine is accelerated beyond
idle speed. (not illustrated)
Anti-Vibration System
The anti-vibration system includes a
number of anti-vibration elements
designed to reduce the
transmission of vibrations created
by the engine and cutting
attachment to the operator's hands.
(not illustrated)
English
43