Send Scene; Saving Your Edits - Peavey PC 1600X Mode D'emploi

the fader itself was not moved).
You can also get a normal "sweep" from the fader by holding the button while moving the fader (or data wheel). In
this case, the "M" will not be on the LCD, signaling that the message is being transmitted.
NOTE: When using faders to send continuous controller messages, the replace and update
modes will be unaffected by fader movements when the button is not pressed. In
other words, the incoming controller won't get filtered until the local controller is
REALLY transmitted.

SEND SCENE

You can send any scene from one of the 16 buttons. This is useful when you know that you're going to transmit
particular scenes from a preset. It saves you from having to go to the SCENE page, choose the scene, and then
send it with the ENTER button.
Choose "Send Scene" as the button function, and the next screen will allow you to pick the desired scene.

SAVING YOUR EDITS

Use the following steps to save your edits:
1. Press the Edit button.
2. Use the data wheel, up/down buttons, or press button 16 to scroll to the last option: Name/Save preset.
3. Press Enter.
4. To re-name, use the left/right buttons to select character positions and the up/down buttons to edit the
character. Note: Faders also can be used to select character positions.
5. Press Enter.
6. Choose the destination preset (will be overwritten).
7. Press Enter again to save to the location displayed at the bottom of the display.
To return to the main page at any time, press Exit several times until the main page is reached. If changes were
made to the preset, the preset number will be replaced with "**". This is an indication that the preset in the edit
buffer has been modified but not saved. Press Edit to return to the Edit mode if the changes are to be saved.
Press up or down from the main page to leave this preset. This will cause any changes that were made to be
discarded.
Note: Edits which were discarded can be recovered from the main page if no other preset has been
edited – even after power-down. Increment the preset number above preset 49 and the preset
number is replaced by "**". Pressing Edit returns to the Edit mode with the edit buffer exactly as it was
last time the Edit mode was exited.
BTN01: Function
Send Fader
BTN01: Function
Send Scene
BTN01: Scene
[p:32] 02
30