Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ABOUT SCENES
A scene allows a "snapshot" to be taken of the current preset number, fader positions & CV settings. These are
saved in one of the 100 scene locations. Sending a scene will transmit the information for each fader/CV pedal
just as it was saved. The scene will be sent referencing the preset that was active when the scene was saved, not
the preset active when the scene is sent.
Example:
If the current preset is configured to control digital tracks, each fader can be used to adjust the mix on
a specific track. When all faders are set to a desired setting, save this as a scene. Continue to adjust
the faders and save scenes as necessary. During a performance, the scenes saved can easily
be sent to the mixer/recorder/sequencer system even if a different PC 1600x preset is being used.
Repeatedly pressing the Scene button will toggle between the SCENE Send, Store, and INITIALIZE pages.
Note: The original preset that was active when the scene was saved must still be in the same preset
location within the PC 1600x for the correct messages to be transmitted.
SENDING A SCENE
1. Press the Scene button until the following page is displayed:
2. Use the up/down direction buttons or the data wheel to select a scene. Note: The associated preset is
indicated in the lower left corner in parentheses.
3. Press the Enter button to send the scene. The scene will be sent using the preset which was current when
the scene was saved. The scene number will automatically increment to the next scene, allowing
several scenes to be sent quickly.
STORING A SCENE
1. Recall the desired preset to be used.
2. Set all faders and CV inputs to the correct positions.
3. Press the SCENE button until the following page is displayed:
4. Use the up/down direction buttons or the data wheel to select the scene number to save. Note: The assoc-i
ated preset is indicated in parentheses in the lower left corner.
5. Press the Enter button to save the scene. The scene number will automatically increment to the next
scene, allowing several scenes to be stored quickly.
Note: A scene saves the current position of each fader and CV input. Data wheel movements and
soloing/muting a fader have no effect on the data stored in a scene or sent by a scene.
SCENE INITIALIZE
Allows an existing scene to be initialized, which disassociates it with any preset, therefore making it send nothing.
This screen is displayed as follows:
1. Press the Scene button until the following page is displayed:
SCENE:
Send
[Enter]
[p:-––]
00
SCENE:
Store
[Enter]
[p:—––]
00
17
Scenes
Publicité
Table des Matières
