Editing The Buttons; Defining And Naming; Off/Fader Id (No Message); Mute/Solo Fader - Peavey PC 1600X Mode D'emploi

DEFINING AND NAMING

When a button is selected to be edited, the first page displayed selects the function of the button. A button can be
assigned to the following functions:
• Off/Fader ID
• Mute fader
• Solo fader
• Program change message
• Note on/off message
• MIDI string
• MIDI string with button press, MIDI string with button release
• Toggle between two MIDI strings
• Send Fader
• Send Scene
To set the function of a button:
1. Press EDIT, then press a button to select it (in this example, button 16. Press Enter to access the following
page.)
2. Press the right direction button to select the function (it will blink), then use the up/down buttons or data
wheel to select the desired function.
3. Use the up direction button when the function field is not blinking to access other parameters. Press either
of the left/right direction arrows (or exit) to de-select (stop the blinking).
After assigning a function to the button, the button can be named. To name the button:
1. With no parameter selected and a function other than "Off / Fader ID" selected, press the up direction
button until the following page is displayed:
2. Use the left/right direction buttons to select the character in the button name and the up/down direction
buttons, the data wheel, and/or the fader above the button to edit the character.

OFF/FADER ID (NO MESSAGE)

Whenever one of the 16 programmable buttons is programmed as "Off / Fader ID" it will identify its associated fader
when on the top of the preset screen. For example, pressing button 16 would cause the PC 1600x to display "Fdr16
: <fader name>." This allows you to see what the fader is going to do (if it is named) before moving it, without having
to look at the edit screens.

MUTE/SOLO FADER

A button can be assigned to mute the associated fader. Pressing the button will mute the fader by sending the
minimum value for the fader, and then disable the fader. When muted, moving the fader will have no effect. When
the button is pressed again, the current fader message is sent, and the fader is enabled. To program a button to
mute the associated fader, simply select "Mute fader" for the button function.
A button can be programmed to solo the associated fader by simply selecting the "Solo fader" function for the
button. With this function, pressing the button will send the minimum value for each fader except the button's

Editing The Buttons

BTN16: Function
Off / Fader ID
BTN16: Name
<name>
25