CAME FLUO-SW Instructions D'assemblage Et D'installation page 56

7.8 ELECTRICAL CONNECTION OF 001MS9502 PROXIMITY SENSOR
Connect the terminals of the sensor, by cable not supplied by us, to the terminals of the electronic control as follows:
terminal POWER = terminal 0
terminal POWER = terminal 1
terminal COM = terminal 1
terminal NO = terminal 3A, or terminal 3B
For more information, check the installation manual of the sensor.
7.9 ELECTRICAL CONNECTION OF 001TSP01 TRANSPONDER PROXIMITLY READER
Connect the badge reader using the supplied cable (Note: lengthen cable not supplied) to terminals of the electronic control
as follows:
black wire = terminal 0
red wire = terminal 1
white wire = terminal 1
white wire = terminal 3A, or terminal 3B
For more information, refer to the installation manual of the transponder reader.
FA00008-EN v.7 – 05/2017 22 CAME S.p.A.