CAME FLUO-SW Instructions D'assemblage Et D'installation page 43

Table des Matières

Les langues disponibles

Remove the cover and fix the automation in a stable and leveled way to the wall using the measurements shown in the

figure; refer to the axis of the door hinges.

Fix the sliding arm on the door as shown in the figure. Insert the sliding arm in the guide and fix to the automation

screw M8 x

50)

Note: if necessary, you can change the measure H, between the automation and the door,

codes listed in the

table.

(H)

PBBS2 automation

001PBBA01 + 001PBBA06

001PBBA01

001PBBA01 + 001PBBA08

PRE-CHARGING OF THE CLOSING SPRINGS

Tighten the screw [a] and compress the springs of about X = 10 mm, as shown in the figure.

Move the door manually, and verify the correct opening and closing force.

Adjust the opening mechanical stop inside the sliding arm.

CLOSING OF THE AUTOMATION COVER

Attach the cover profile to the base profile. To prevent the cover from being opened without the use of a tool, you can

secure the cover to the heads at the holes, using the screws 2,9 x9,5 not supplied by us.

FA00008-EN v.7 – 05/2017

by replacing the spacer, using the

CAME S.p.A.

(use the

Table des Matières