Installation; Safety - Dantherm AD 200 Instructions De Service

Safety

Introduction
Safety devices
Authorized
operator
Risk of misuse
Hazards from
accessories
8
This section describes the safety regulations which have to be followed when installing and
maintaining the adsorption dryer.
All persons involved in the installation, commissioning, operation and maintenance of the
devices must
• be properly qualified,
• closely observe the instructions set out in this manual.
Work on the internal components may only be carried out by the manufacturer or personnel
authorised by the manufacturer. This work involves danger of electric shock, burns, crushing,
entanglement and cutting.
Operation of or other work on the adsorption dryer incl. electrical equipment may only be
carried out by persons commissioned and instructed by the user. In the working area the
operator is responsible to third parties.
Responsibilities for the various activities on the device must be clearly defined and observed.
Unclear competencies are a safety risk. The user must:
• make the instruction manual accessible to the operator and
• make sure that the operator has read and understood the instruction manual.
The series AD 200 / 300 adsorption dryers were subjected to thorough safety testing.
Improper operation or misuse will cause danger to:
• the operator,
• the machine and other material property of the user,
• efficient operation of the machine.
Hoses and air filters must be properly installed and must not disable the protection devices of
the adsorption dryers. The operating elements must always be accessible.
Original spare parts or spare parts approved by the manufacturer shall exclusively be used.

Installation