Dantherm AD 200 Instructions De Service page 16

Maintenance and service, continued
Warning
WARNING
Caution
Warning
WARNING
Caution
Warning
CAUTION
Caution
Warning
CAUTION
Caution
Warning
CAUTION
Caution
16
Danger of injury by electric shock and risk of material damage
• Always observe the general safety instructions when performing any maintenance and
service work!
• Switch the device off and pull the power plug before cleaning and inspection.
• Inspection and any work inside the device may only be carried out by trained expert staff.
Danger of injury due to dirt whirled up and compressed air
• Wear protective goggles during cleaning with compressed air!
Danger of cutting when reaching into inlet or outlet openings .
Danger of cut injuries at air inlet and outlet.
• Do not reach into the openings; carry the device exclusively by the handle.
Dust hazard
During cleaning with compressed air dust is released into the atmosphere.
• Clean air filter from outside and inside with a vacuum cleaner, if necessary wash and dry it.
• Clean device with compressed air only in an open environment; wear protective mask and
protective goggles.
Damage to the device
Cleaning agents can cause damage to surfaces.
• Use only mild detergents.
• Never operate the adsorption dryer without filter or when the filter is soiled.