Installation - Dantherm AD 200 Instructions De Service

Installation

Introduction This section describes how to install the electrical connection of the series AD 200 / 300 ad-
sorption dryers correctly
Electrical The following items must be checked prior to electrical connection of the adsorption dryer:
connection
• Is the mains voltage in conformity with the voltage of the device?
• Are socket and supply system sufficiently fused?
• Has an RCCB been installed?
• Is the appliance coupler suitable for the building socket outlet?
• Is the socket outlet used grounded properly?
Step
1
2
Danger to life due to electric shock
Warning
DANGER
• Prior to commissioning the technical data of the adsorption dryer must be compared with
the conditions prevailing in the room of installation!
Caution
• Use exclusively the original power cable! In case of loss or damage original power cables
are available from your adsorption dryer supplier.
Action
Connect the appliance coupler of the power cable included in
the delivery to the socket on the adsorption dryer.
Connect the power cable of the adsorption dryer to a suitable
power outlet.
Illustration
11