Hygrostat Control - Dantherm AD 200 Instructions De Service

Operation and operator control, continued

Hygrostat control

Adjusting
the hygrostat
controller
!
TIP
!
TIP
Warning
CAUTION
Caution
Activating /
deactivating the
drying process
14
This illustration shows the hygrostat controller of the AD 200 and AD 300.
The hygrostat controller of the device can be used to set the desired humidity value. The
hygrostat is arranged clearly visible in the operating panel.
Continuous adjustment of the hygrostat allows for easy humidity control.
Hygrostat position
Position 0
Position I
Position 80%
Position 60%
Position 40%
Position 20%
If very precise setting values are required, use a hygrometer with a precise humidity display to
set the hygrostat.
For quick building drying the hygrostat is set to continuous operation (item I).
For drying and keeping rooms with wood furnishing (e. g. parquet flooring) or paintings,
antiques etc. dry, a minimum moisture of 55 – 60% must be observed.
In case of doubt please contact your technical advisor.
Damage to the device
• When the adsorption dryer is used in combination with a side channel compressor / noise
box: always set the hygrostat to position I.
Select the desired humidity on the hygrostat (Fig. 5) and switch the adsorption dryer on via
the On / Off switch (Fig. 1 and Fig. 2). The On / Off switch lights when the device is switched
on. When the drying process has been finished switch the device off via the On / Off switch.
h
kWh
AD 200
80%
60%
60%
40%
20%
Fig. 5
Significance, device response
Device ready for operation
Device running in continuous mode
The adsorption dryer will switch off at a
relative room humidity of about 80% and
switch on again when a humidity of 80% is
exceeded.
The adsorption dryer will switch off at a
relative room humidity of about 60% and
switch on again when a humidity of 60% is
exceeded.
The adsorption dryer will switch off at a
relative room humidity of about 40% and
switch on again when a humidity of 40% is
exceeded.
The adsorption dryer will switch off at a
relative room humidity of about 20% and
switch on again when a humidity of 20% is
exceeded.
AD 300
20%
40%
80%