Coolant Level Check - SWM SM 500 R E4 2018 Manuel - Utilisation - Entretien

• Refit everything operating in reverse order from
removal taking care to correctly position the O-
ring (20) and the spring (21).
WARNING*: The screw (15a) is longer and must
be mounted exactly in the position indicated
in the figure.
[Coupling torque of screws (13), (15) e (15a) 10
Nm/ 1 Kgm/ 7,38 ft/lb.]
15a
18
15
21
EN - 30

COOLANT LEVEL CHECK

Check level (1) in right-hand radiator when engine is
cold (place the motorbike fully upright). The coolant
must be 10 mm above the elements.
The coolant must always be present in the
expansion tank (2); its level must always be above
the MIN mark indicated in the figure.
If that is not the case, top up through the cap (4).
The radiator cap (3) is provided with two locking
positions: the first one is for prior discharge of pres-
sure in the cooling system.
CAUTION*: Avoid removing radiator cap (3)
when engine is hot, as coolant may spout out
and cause scalding.
Note*: Difficulties may arise in eliminating coolant
from painted surfaces. If this occurs, wash off with
water.
20
19
1
MIN
2
4
3