SWM SM 500 R E4 2018 Manuel - Utilisation - Entretien page 118

CAUTION*: Do not spill brake fluid onto any
painted surface or light lens.
CAUTION*: Do not mix two brands of fluid.
Completely change the brake fluid in the brake
system if you wish to switch to another fluid
brand.
CAUTION*: Brake fluid may cause irritation.
Avoid contact with skin or eyes. In case of con-
tact, flush thoroughly with water and call a
doctor if your eyes were exposed.
EN - 40
HYDRAULIC CLUTCH FLUID LEVEL CHECK
To check the fluid level, proceed as follows:
- remove screws (1), cover (2) and rubber (3) pump
diaphragm on the handlebar clutch control;
- by keeping the master cylinder (4) in horizontal
position, check the fluid level is NOT BELOW 4 mm
(0.16 in.) from the upper surface (D) of the pump
body;
- if necessary, add fluid until the correct level is
reached see TABLE FOR LUBRICATION-SUPPLIES
for the fluid type.
CAUTION*: NEVER use brake fluid.
Reassembly the removed parts using the reverse
procedure.
1
C
4
2
Periodically check the connecting hose (see "Periodi-
cal maintenance card"): if the hose (C) show is bent
or cracked, its replacement is advised.
1
2
3
D