SWM SM 500 R E4 2018 Manuel - Utilisation - Entretien page 134

- Pump with brake lever (3) or brake pedal (3A) in
order to push brake fluid out of line.
- Close the bleeding valve and fill the reservoir
with fresh brake fluid.
- Open the bleeding valve, apply the brake us-
ing the brake lever or pedal, close the bleeding
valve with the brake lever or pedal applied and
then quickly release the lever or pedal.
- Repeat this operation until the brake line is filled
and clear fluid starts coming out of the plastic
hose: now close the bleeding valve.
- Restore the brake fluid level (A) or (B) then reas-
semble the rubber and the fluid reservoir cap.
After changing the fluid, bleed the system as de-
scribed in the relative paragraph.
EN - 56
3
B
A
3A
WARNING*:
Brake fluid quickly ruins painted surfaces; any
spilled fluid should be completely wiped up im-
mediately.
* Brake fluid may cause irritation. Avoid con-
tact with skin or eyes. In case of contact, flush
thoroughly and call a doctor if your eyes were
exposed.
Periodically check the connecting hoses (see
"Periodical maintenance card"): if the hoses
(A) and (B) are worned or cracked, their re-
placement is advised
A
B