Fortress Building Products AL13 HOME Instructions D'installation page 31

Step 2: ATR Angle Splice (OTP)
1. Install ATRs and Spacers opposite of the Angle Bracket first.
2. Measure from the inside of the post and add 2" [51mm] to the
over all length.
3. Install ATRs and Spacers on the Angle side measuring from
the end of the Bracket Cup adding 2-1/2" [63.5mm] to the
overall length.
4. Once both ATRs are installed center Angle Splice over Angle
Bracket.
5. Secure Angle Splice on ATRs with a Rubber Mallet.
Note:
• ATR should overhang Post 1" [25.5mm] in each side.
Fig. 1
ATR Should Over Hang on Post 1" [25.5mm]
on Both Sides
Fig. 3
AL
Fig. 4
HOME TRADITIONAL PANEL INSTALLATION
13
Fig. 2
31