Fortress Building Products AL13 HOME Instructions D'installation page 24

ANGLE BRACKET: POST MOUNTING
• Reference OTP & Proud Post mounting instructions on page 5.
Note:
IT'S RECOMMENDED TO INSTALL BRACKETS ON TO POST BEFORE
POST MOUNTING.
ANGLE BRACKET: BRACKET INSTALLATION
Step 1: Mark Bracket Hole Locations
1. Mark the centerline of each post with a pencil.
2. Take measurements used in Fig. 1 and 2 to mark bottom and
top bracket hole locations onto posts.
Note:
• Installed panel heights include space between the deck surface
and underside of bottom rail. AL
panels have a 3-1/2" [89mm] space. AL
[1,016mm] panels have a 2" [51mm] space.
Fig. 1
Pre-Drill Dimensions: Pre-Drilling with a 3/16" [ 4.5mm] drill bit is required.
4-3/16" [106.5mm]
2-9/16" [65mm]
*Dimension A positions bottom edge of rail 3-1/2" above deck surface.
*Dimension A is measured from the bottom surface of post base.
Fig. 2
B
24
Bracket Hole Locations
A*
35-3/8" [899mm]
41-5/16" [1049mm]
A
C
AL HOME TRADITIONAL PANEL INSTALLATION
13
HOME 32.5" [825.5mm]
13
HOME 40"
13
B
1" [25.5mm]
1" [25.5mm]
A
C