Fortress Building Products AL13 HOME Instructions D'installation page 18

Step 3: Apply Screws
1. Attach the panel to each of the 4 brackets using the provided
self-drilling screw with a T-25 Bit.
Tip: Pre-drill with a 3/16" [4.5mm] drill bit.
NOTE:
• Only one screw is needed to secure the bracket to
the panel.
Fig. 1
Step 4: Attach I-Support To Deck
• Reference OTP I-Support Attachment instructions on page 1 1.
Step 5: Install Bracket Caps
1. Bracket Caps snap down over Bracket Cups.
• If you are installing a drink rail using the Cap Rail Clips, the
cap is installed under the bracket. See page16 for details.
• The top bracket cap can be installed when using an ATR but is
not required to be installed.
Fig. 1
18
Fig. 2
AL HOME TRADITIONAL PANEL INSTALLATION
13