Fortress Building Products AL13 HOME Instructions D'installation page 20

Step 2: Round ATR
1. Measure the distance from the inside edge of the 2 posts.
2. Cut the ATR to measured length.
3. When test fitting the ATR, place it on top of the spacers. Do not
press the ATR down over the spacers. Removing the ATR from the
spacers can damage the ATR and spacers. As shown in Fig. 2.
4. Remove the backing of all of the double-sided tape on the
ATR spacers.
5. A Rubber Mallet might need to be used to install. If using a
Rubber Mallet, use a cloth to protect the ATR from damage.
Fig. 1
Fig. 2
ATR Should Go Past This
Point When Test Fitting
PROUD POST: FLAT ACCENT TOP RAIL (ATR)
Step 1: Flat ATR Spacers
1. Measure distance between brackets and cut ATR Spacer to
length. The Spacer can be 1/4" [6.5mm] shorter than the
distance between brackets.
20
AL HOME TRADITIONAL PANEL INSTALLATION
13