Fortress Building Products AL13 HOME Instructions D'installation page 15

CORNER
Fig. 4
1/2"
[12.5mm]
1/2"
[12.5mm]
OTP: FLAT ACCENT TOP RAIL (ATR)
Step 1: Flat ATR Spacers
1. Measure distance between brackets and cut ATR spacer to
length. The spacer can be 1/4" [6.5mm] shorter than the
distance between brackets.
2. If one of the screw holes was cut off during the sizing of the
ATR spacer, use a 5/8" [16mm] drill bit to add another hole
1" from the end of the ATR spacer.
3. Attach the ATR spacer using the provided self-drilling screws
with a 5/16" [8mm] nut driver.
4. All screw holes must have a screw installed.
Note:
• Flat ATR uses a full length ATR spacer.
• DO NOT REMOVE BACKING OF DOUBLE SIDED TAPE
UNTIL YOU ARE READY TO PERMANENTLY ATTACH
THE ATR.
Fig. 1
AL
Fig. 5
1/2"
[12.5mm]
HOME TRADITIONAL PANEL INSTALLATION
13
LINE
Fig. 6
1/2"
[12.5mm]
END
1/2"
[12.5mm]
15