Fortress Building Products AL13 HOME Instructions D'installation page 30

ANGLE BRACKET: ROUND & FLAT ATR MITER SPLICE
Step 1: ATR Angle Splice (Proud Post)
1. Use 3/32" [2.5mm] hex wrench to tighten set screw and lock
Angle Bracket at 45
2. Place Angle Splice on top of ATR butting up the end face of the
splice to the face of the 3" [76mm] post. As shown in Fig 3, 4.
3. A Rubber Mallet might need to be used to install. If using a
Rubber Mallet, use a cloth to protect the ATR from damage.
4. Secure Angle Splice with two #6-20 x 1/2" [12.5mm]
self-drilling screws.
Note:
• Angle Splice only work if brackets are angled at the
45
o
Fig. 1
45
o
Fig. 3
Butt These
Two Faces
30
o
degree setting.
AL HOME TRADITIONAL PANEL INSTALLATION
13
degree position. As shown in Fig. 1, 2.
Fig. 2
Bracket Has
To Be Set At
This Setting
Fig. 4
Bottom of
Bracket