Fortress Building Products AL13 HOME Instructions D'installation page 13

Step 2: Round ATR Line and End Posts
1. Measure the distance from the inside edge of the 2 posts.
2. Cut the ATR to measured length.
3. The ATR cannot block the inside edge of the post. As shown in
Fig. 2.
4. When test fitting the ATR, place on top of the spacers. Do not
press the ATR down over the spacers. Removing the ATR from
the spacers can damage the ATR and spacers. As shown in
Fig. 3.
5. Remove the backing of all of the double-sided tape on the ATR
spacers.
6. A Rubber Mallet might need to be used to install. If using a
rubber mallet, use a cloth to protect the ATR from damage.
Fig. 1
Fig. 2
ATR Cannot Go
Past This Line
AL HOME TRADITIONAL PANEL INSTALLATION
13
Fig. 3
ATR Should Go Past This
Point When Test Fitting
13