Fortress Building Products AL13 HOME Instructions D'installation page 27

Fig. 2
ANGLE BRACKET: CUTTING DOWN PANELS
• Reference page 8 for panel cutting steps.
ANGLE BRACKET: INSTALL PANEL
Step 1: Install I-Support On Panel
1. Install the panel I-support by twisting it into the center of the
bottom rail directly under a baluster. As shown in Fig. 1.
2. Position the I-support so the attachment screw can be easily
installed on the deck.
Fig. 1
Step 2: Install Panel
1. Use level to ensure that all panels are at the same height
before attaching them to the post.
• The use of an ATR Spacer or block might be needed to
measure over a post.
AL
Do not measure
from post
Measure from back
of bracket
HOME TRADITIONAL PANEL INSTALLATION
13
27