Fortress Building Products AL13 HOME Instructions D'installation page 14

Step 3: Round ATR Corner
1. When installing ATR on corners with a 2" [51mm] post, the ATR
must be 5/16" [8mm] away from the post. As shown in Fig. 1.
2. If installing a corner with a 3" [76mm] proud post, install the
ATR at full length from the inside edge of the post to the inside
edge of the post.
Fig. 1
2" Post
[51mm]
5/16' [8mm]
Minimum
ATR With 2" [51mm] Proud Post
Step 4: Round ATR Splice
1. To install an ATR splice: Center the splice over the post and
with force press down over the ATR. As shown in Fig. 1,2,3.
2. A Rubber Mallet might need to be used to install. If using a
Rubber Mallet, use a cloth to protect the splice from damage.
• ATR splices reference the inside of the post and snap down
around the ATR.
• ATR splices allow up to 1/2" [12.5mm] of length variation
from the edge of the post. As shown in Fig. 4,5,6.
CORNER
Fig. 1
14
5/16' [8mm]
Minimum
Over The Post
Fig. 2
AL HOME TRADITIONAL PANEL INSTALLATION
13
Fig. 2
3" Post
[76mm]
ATR
ATR With 3" [76mm] Proud Post
Over The Post
LINE Fig. 3
ATR
END