Spypoint TINY-3 Manuel D'utilisation page 13

24
Allow the user to set the frequency at which time
Time Lapse:
(Off/30s/1m/3m/ the camera takes a picture, without detection.
5m/15m/30m/1h)
For example, if the option «5 minutes» is
selected in the «Time Lapse» mode, the camera
takes a picture every 5 minutes during that
period of operation (time start and time stop)
even if there is no detection.
This option allows the user to obtain
pictures of game outside the detection range
of the camera.
Note: The «Time Lapse» mode only applies
in «Photo» mode, not in «Video» mode.
When «Time Lapse» mode is selected, the
«Delay» mode and the «Multi-shot» mode
are disabled. In addition, the photo
resolution is reduced to 800 x 600 to allow
the possibility of video editing.
The RC-1 remote control is required (sold
RC-1
separately, see «Options»). Allows the user
(Remos):
( to pause the picture taking of the camera
On/Off)
(#1/2), to remotely take a photo on command
1 2
(#3) or to activate the buzzer signal on the
controller (TINY-W3/S-TINY-W3 only) in
4
3
an area of 500ft (#4).
The MS-1 motion sensor is required (sold
MS-1
separately, see «Options»). Allows the
(Remos):
(On/Off)
camera to be triggered wirelessly by one or
more MS-1 devices.
Allows the camera to trigger, up to a distance
IR-Booster
of 50 ft, one or more remote IR-BOOSTER
(Remos):
(On/Off)
infrared lighting devices without the use of
an additional transmitter.
REPORT
The report mode keeps a record of the last period of
use of the camera. The beginning date corresponds
with the moment the camera is set to either «Photo» or
«Video» mode. Thus, the report is reset when changing
modes.
1.
2.
3.
4.
5.
6.
7.
8.
9.
25