Safety Instructions; Important Installation Instructions - RADEMACHER RTSS Serie Instructions De Montage Et De Service

Moteurs tubulaires
Origine: rademacher.de
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

General safety instructions
There is always danger of a potentially fatal electric shock when
working with electrical systems.
The tubular motor must only be connected to and all work performed on electrical
equipment must only be carried out by a qualified electrician in accordance with
the diagrams provided in these instruction (see pages 38/39/40).
Carry out the installation and connection with all devices disconnected from the
mains.
Non-observance can cause danger to life!
Observe installation instructions for installation in damp rooms.
Please observe regulation DIN VDE 01000, part 701 and 702 in particular when
using the motor in damp rooms. These regulations detail mandatory safety measures.
Use of a defective device can endanger people and equipment
(electrical shock, short circuit).
Never use defect or damaged devices.
Please make sure that the drive and mains cable are free from damage.
Please notify our customer service department (see page 54) of any faults/
damage on the device.
i
Correct Use / Operating conditions
Tubular motors are intended solely for raising and lowering
shutters.
IMPORTANT
The motor cable inside the empty tube must be laid up to the distribution box
under consideration of local building and electricity regulations.
Only use original manufacturer's parts and accessories.

Important installation instructions

General View ( Figure
(1)
Counter bearing
(2)
Ball bearing
(3)
Axle of the roller cap
(4)
Roller cap
(5)
Winding shaft
(6)
Tie
(7)
Securing clip
(8)
Driver
(9)
Tubular motor
(10) Adapter
(11) Set button
(12) Drive head
(13) Drive end bearing
(14) Fixing bracket
(15) Motor cable
(16) Control device (e.g. Troll C50)
(17) Roller shutter curtain
(18) Limit ring
(19) Gearbox output shaft
(20) Hanging brackets
Please note:
Customer-specific supply package
)
Improper use increases risk of injury.
Please instruct all people concerned in the safe use of the tubular motor.
Always monitor roller shutters while they are moving and keep people at a
distance until movement has finished.
Prohibit children from playing with stationary control units.
When cleaning the roller shutter, the equipment must always be at zero
voltage.
IMPORTANT
According to the standard DIN EN 13695, care must be taken that the sliding conditions
stipulated in EN 12-045 for the hangings are adhered to.
Particular care must be taken here to ensure that the outward running speed of the
hanging is less than 0.2 m/s over the last 0.4 m of travel.
Operating conditions
The electrical connection equires a permanent 230 V/50 Hz power supply at
the site of installation as well as an on-site isolating device (fuse).
IMPORTANT
Please compare the voltage/frequency specifications on the type plate with those
of your local power supply network before installation.
Disassemble or deactivate all cables and equipment that will not be needed for
operation before installing the tubular motor.
The moving parts of drives that are operated at less than 2.5 m height from the
floor must be protected.
If the tubular motor is controlled with a preset OFF switch this switch must be
fitted within view of the tubular motor, at a minimum height of 1.5 m and
away from moving parts.
It is vital that the winding shaft is fitted horizontally!
It is vital that the roller shutter is wound up evenly, as this could otherwise
cause damage to the motor and shutter.
The roller shutter box cover must be easily accessible and removable.
Please compare:
The contents of the package with the content description on the packaging
after unwrapping it.
The motor designation with the relevant information included on the type plate.
NL GB F
GB
35
ES
D

Publicité

Table des Matières
loading

Table des Matières