Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
STEP 1. ATTACHING THE STABILIZERS
Attach the Rear Stabilizer first by lifting up the
rear of the frame and sliding the rear stabilizer
under the frame. Align the holes of the stabilizer
and frame then insert Bolts (8) from below.
Secure the bolts with 2 Washers (7) and 2 Nuts
(6). Use the wrench provided. Use the same
procedure to secure the Front Stabilizer.
STEP 2. ATTACHING THE
HANDLEBAR POST
Slide the Handlebar Post (21) into the
headtube on the frame. Make sure the
Release Lever (2) is loose enough so the
Handlebar Post can slide down to the
desired position. Tighten the Release
Lever (2) to secure.
STEP 3. ATTACHING THE
HANDLEBAR
Seat the Handlebar (20) on top of
the Handlebar Post (21) and secure
by screwing in the Release Lever (17)
from below.
14
Publicité
Chapitres
Table des Matières
