BH LK700IC Manuel Du Propriétaire page 15

STEP 4. ATTACHING THE
SEAT ASSEMBLY
Insert the Seat Post (39) into the seat tube
on the frame to the desired height and
secure with the Release Lever (2). Slide
the Seat Post Slider (38) into the Seat Post
(39). Adjust to desired position and secure
with the release lever on the bottom of the
Seat Post (39). Slide the Seat (1) onto the
Seat Slider (38) and secure the Seat (1) by
tightening the nuts on both sides of the
seat clamp on the underside of the seat.
Use wrench provided.
STEP 5. ATTACHING THE PEDALS
Each pedal is marked either with an (L)
for Left or an (R) for Right. Thread the
pedal into the Crank on the corresponding
side. The Pedals tighten clockwise. Use the
15mm wrench provided to tighten.
15