Power Supply - Elkron IS200 Mode D'emploi

POWER SUPPLY

IS200 features completely wire-free operation and uses four alkaline D cells. The battery-life is estimated
for 3 years.
The IS200 can detect if the battery is low. Low battery detection operates where the IS200 has enough
power to typically operate for 1 month before complete exhaustion. The siren low battery signal will be
enunciated by five beeps under Operation Mode.
On the other hand, during an alarming period low battery status, the siren sound will be incomplete. For
Burglary, Fire and water alarm duration, IS200 gives an intermittent alarm sound of 500 ms, 460 ms and
460 ms ~ 1400 ms of cyclical accordingly.
IS200 FUNCTION OVERVIEW
•
Siren Audible Performance
The siren produces a minimum of 104 dBA sound pressure at 1 meter on axis. It is
programmable via two DIP switches (SW3 and SW4) for four different siren durations:
1) 3 min.
2) 5 min.
3) 10 min.
4) 1 second (for testing)
The fourth position (1 second) is used for testing during installation.
o
For Burglar / Panic Alarm, IS200 gives a continuous alarm sound.
o
For Fire / Water alarm, IS200 gives an intermittent alarm sound of 2-sec siren followed by
o
a 1 sec interval, cyclically during the programmed alarm duration.
The siren is silenced when either the programmed siren duration expires or the Control
o
panel turns off the siren.
•
Previous Alarm Warning
If there has been an alarm while you were away, the IS200 sounds alarm while the system is
disarmed.
WARNING: If the siren is activated for 3 seconds when you disarm your system, it is reminder
you that there could be an intruder still in your premises.
•
Audio Status Indication
While arming / disarming the system, the IS200 uses different methods to distinguish various
1statuses for the user, as listed in following table:
Note:
For those marked with asterisk (*), it means the Siren Audio indication will be effected by the
Confirmation ON / OFF. When setting Confirmation to OFF, the confirmation sound will not be
available.
•
Factory Reset
The siren can be reset and memory contents cleared by following steps:
Step 1: First, put the Control Panel into Device +/- menu and then select Remove Device menu.
Refer to the operation manual of your Control Panel under the section of Device +/- to
complete the IS200 removal procedure.
Step 2: Open the top case of IS200 and the battery lid.
Step 3: Remove the batteries, and then press the tamper switch once for discharging.
Step 4: Slide DIP SW 6 to ON position and restore the battery. The siren will produce a short
confirmation tone.
Step 5: Slide the DIP SW 6 back to OFF position. The IS200 returns to normal mode and the
programming memory is clear.
Arm/Home
Disarm
Arm/Home (Low Battery)
Disarm (Low Battery)
Arm/Home (Tamper)
Disarm (Tamper)
Previous alarm warning
Tamper Alarm
Entry/Exit Sound
Siren Audio
1 beep*
2 beeps*
5 beeps
5 beeps
5 beeps
5 beeps
3 secs beep
Continuous beeps
Count-down beeps
2/16