Installation Procedure - Toyota CIIT1287 Instructions D'installation

TOYOTA RAV4

INSTALLATION PROCEDURE:

Figure 1-1
Figure 1-2
Figure 2
Issue C: February 4, 2013
- 2013 -
Note: If installing the Trailer Wire Harness, refer to the
Trailer Wire Harness installation instructions for interior
disassembly and wire routing.
Skip to Step 6.
Step 1
Check contents of kit before commencing fitment.
Remove Tonneau Cover and Lift out Trunk Floor Panel.
See Figure 1-1.
Remove LH Storage Tub by removing 3x Clips. Pull up to
release.
Retain all parts.
See Figure 1-2.
Phillips #2 Screw Driver
Step 2
Remove Rear Scuff Panel. Pull up to release.
Remove Rear Intermediate Cover by removing 4x Phillips Head
Screws. Pull up to release.
Retain all parts.
See Figure 2.
Page 4 of 21
TOWING HITCH