Publicité
Les langues disponibles
Les langues disponibles
TOYOTA RAV4
Figure 20
Figure 21
Figure 22
Issue C: February 4, 2013
- 2013 -
18mm Socket 1/2" Drive, Ratchet, 18mm Wrench
Step 20
Loosely secure Towbar Centre Section (Item 1) to Sidearms
(Items 3 & 4) using 6x M12 Bolts, 12x M12 Washers & 6x M12
Nuts (Items 13, 14, & 15).
See Figure 20.
18mm Socket 1/2" Drive, Ratchet, 18mm Wrench
Step 21
Loosely secure 1x Shim Plate (Item 11) and LH Rear Bracket
Assembly (Item 8) between Towbar Centre Section (Item 1) and
Rear Panel. Secure to Rear Panel with 3x M8 x 35 Bolts &
Washers (Items 16 & 17). Secure to Towbar Centre Section
(Item 1) with 2x M12 Bolts, 4x M12 Washers & 2x M12 Nuts
(Items 13, 14 & 15).
Repeat for RH Side.
See Figure 21.
13mm, 18mm Socket 3/8" Drive, 18mm 1/2" Drive,
Med. Extension 1/2" Drive, Torque Wrench 3/8" Drive,
Torque Wrench 1/2" Drive
Step 22
Ensure alignment of Centre Section to Side Arms and center of
vehicle. Torque Fasteners in the following sequence:
1) M12 Centre Section to Rear Corner Brackets - 92 Nm (67.9
ft-lbf)
2) M8 Rear Corner Brackets to Body - 25 Nm (18.4 ft-lbf)
3) M12 Chassis Vertical Connections – 92 Nm (67.9 ft-lbf)
4) M12 Chassis Horizontal Connections – 92 Nm (67.9 ft-lbf)
5) M12 Centre Section to Sidearms – 92 Nm (67.9 ft-lbf)
6) M8 Nut Plates – 25 Nm (18.4 ft-lbf)
See Figure 22.
NOTE: Forward most LH bolt of Centre Section to Side
Arm may require a 3/8" Drive Socket and Extension used
through the Tow Hook hole to tighten.
Page 12 of 21
TOWING HITCH
Publicité
