Toyota CIIT1287 Instructions D'installation page 14

TOYOTA RAV4
Figure 23-1
Figure 23-2
Issue C: February 4, 2013
- 2013 -
Scissors, Tin Snips
Step 23
Use the template provided on page 21 to cut the centre section of
the rear bumper following the steps below.
Ensure that all dimensions of the template are to scale before
proceeding.
1. Cut lower edge of template using scissors.
2. Generously apply tape to the anticipated cutting area on the
Bumper to protect it from damage. See Figure 23-1.
3. Position the template on the outside of the Bumper.
4. Align edge on template with the lowest edge on the Bumper
and tape the template to the Bumper. Apply additional tape to
the the main cutting edges of the template as a visual aid for
cutting the Bumper. See Figure 23-2.
Page 13 of 21
TOWING HITCH