Toyota CIIT1287 Instructions D'installation page 7

Rav4 2013
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TOYOTA RAV4
Figure 5-1
Figure 5-2
Figure 6
Issue C: February 4, 2013
- 2013 -
10mm, 14mm Socket 3/8" Drive, Ratchet w/ Med.
Extension, Phillips #2 Screw Driver
Step 5
Remove LH Rear Interior Trim Panel by removing; 1x Seat Belt
Lower Mount Bolt, 1x Cargo Tie Down Bolt, 3x Small Mount
Bolts & 1x Phillips Head Screw.
Lift LH Rear Doorway Scuff Panel.
Lift Rear Door Weatherstrip
Pull LH Rear Interior Trim Panel to release.
Disconnect LH Interior Light Plug.
Retain all parts.
Repeat for RH Side.
See Figure 5-1 and 5-2.
Note: If installing the Trailer Wire Harness, start here.
Phillips #2 Screw Driver
Step 6
Remove LH Mud Flap by removing 3x Screws in the Wheel
Arch and 2x Screws underneath.
Retain all parts.
Repeat for RH side.
See Figure 6.
Page 6 of 21
TOWING HITCH

Publicité

Table des Matières
loading

Table des Matières