APA BULLY Mode D'emploi page 7

Low (red): The accumulator has to be recharged immediately.
Medium (green): The accumulator should be recharged soon.
High (green): You do not have to recharge the accumulator.
The "Bully" Power Pack possesses an internal power supply unit. To start the charging of the internal
accumulator of the device, just connect the mains plug of the "Bully" Power Pack to a socket. Then the
red LED which indicates the charging level will light up. The internal power supply unit is an automatic
battery charger with voltage stabilizer which the internal accumulator from being overcharged. This
innovative technology makes it possible to keep the device connected to the socket for a long time
without running the risk of damaging the Power Pack.
Troubleshooting:
In order to ensure a troublefree use of your "Bully" Power Pack, you should pay special attention to the
following points:
1. When you buy your "Bully" Power Pack, the internal accumulator has already been charged.
Nevertheless you should recharge it once for a short time before using the device.
2. The internal accumulator should only be charged with the accessories provided by the manufacturer.
3. The Power Pack is only constructed to supply low-voltage loads (of 12 Volt) which need direct current
with energy. By contrast, loads that need 110/230 or 240 Volt alternating current cannot be supplied
with energy by this Power Pack.
4. If the LED "low" which indicates the level of charging lights up, the current source has to be recharged
immediately.
5. Avoid recharging your "Bully" Power Pack at temperatures lower than 39,2°F / 4°C or higher than
104°F / 40°C.
6. Do not expose your "Bully" Power Pack to rain or moisture.
7. If your "Bully" Power Pack is not in use, it should nevertheless be kept fully charged. If you want to
store it for a long period of time, you should recharge the device every four to six weeks.
8. It can be dangerous to connect loads with reversed polarity to the Power Pack. So it is best to check
the polarity of the load you want to supply with energy before actually connecting it to your "Bully"
Power Pack.
9. If you are going to use the output contacts of the Power Pack, make sure that the positive pole of the
plug for cigarette lighters of the load to be supplied with current is at the central pin. If you are not sure
about this, ask a qualified technician for help.
How to replace the internal accumulator:
The internal accumulator of the "Bully" Power Pack runs for a long time if it is maintained correctly. If
nevertheless the accumulator cannot be recharged any more, it should only be replaced by a qualified
technician. The accumulator of the Power Pack can be replaced by any standard accumulator of the
same type.
7