Start-Up Procedure And Operation; Before First Use: Cleaning The Milk Collection Kit - Ameda Mya Mode D'emploi

4. START-UP PROCEDURE AND OPERATION

4.1. Before First Use: Cleaning the Milk Collection Kit

Before first use, unless otherwise directed by your
healthcare provider, prepare the product for use as follows:
1. Remove tubing from the back-flow protector
2. Set aside tubing, it does not need to be washed before
first use or after each use—milk does not come into direct
contact with it.
Take apart the remaining parts: the flange(s), valve(s),
back-flow protector(s), separating out the top, silicone and
bottom pieces, and milk storage bottle(s), including locking
ring(s) and locking disc(s).
Cleaning: Cleaning by Boiling
WARNING: Do Not Leave Boiling Parts Unattended
Remove parts carefully from boiling water to avoid burning. Boiled water
and steam from boiled water can cause severe burns, so use caution
when boiling parts in water and removing parts from boiling water.
1
• BOIL a pot of clean
water
• Put flange(s),
valve(s), back-flow
protector top(s),
locking ring(s) and
locking disc(s)
into pot for 20
MINUTES.
10
2
• WASH your hands
ALWAYS wash
hands well with soap
and water
3
• REMOVE the parts
carefully with
clean tongs
DO NOT allow
boiling parts to
contact bottom of
pot. It may cause
damage to parts.
WARNING
DO NOT wash or
boil tubing. Tubing
needs to remain
dry to avoid any
potential mold
contamination.
4
• Air DRY on a clean
surface
* Parts may vary