Publicité
3
Inspection, points to verify
Before each use
Harness
Check the webbing at the attachment points, at the
adjustment buckles and at the safety stitching.
Look for cuts in the webbing, wear and damage due to
use, to heat, and to contact with chemical products, etc.
Be particularly careful to check for cut threads.
Verify that the DoubleBack and FAST buckles operate
properly.
Check the fall arrest indicator. The indicator shows red if
the dorsal attachment point sustains a shock-load greater
than 400 daN. Do not use the harness anymore if the fall
arrest indicator is visible.
Front connector/buckle
Make sure the frame, gate, and locking sleeve are free of
any cracks, deformation, corrosion, etc. Open the gate and
verify that it closes and locks itself automatically when
released. The Keylock slot must not be blocked by any
foreign matter (dirt, pebble, etc.).
During each use
It is important to regularly inspect the condition of the
product. Make sure that all pieces of equipment in your
system are correctly connected and positioned with
respect to each other.
Consult the details of the inspection procedure to be
carried out for each type of PPE on the Web at www.petzl.
com/ppe or on the PETZL PPE CD-ROM.
Contact PETZL if there is any doubt about the condition of
this product.
5
How to put the harness on
Open the buckles on the leg loops.
5A. Putting the
5B. Adjust the waistbelt by
shoulder straps off
pulling on the waist-belt
to one side, hold
straps. Stow the excess
the seat harness by
webbing neatly (flat - no
the waistbelt and
loops of slack) using the
slip it on over your
strap retainers.
legs.
5A.
5B.
- Short ends: use the
retainers in front of the
adjustment buckles.
- Long ends: pass them
through the lateral
rings then through the
retainers behind the
rings.
3
NAVAHO BOD C71000 B / NAVAHO BOD FAST C710F0 B / NAVAHO BOD FAST NOIR C710FN B
4
Compatibility
WARNING, when using multiple
pieces of equipment together, a
dangerous situation can result if
the safety function of one piece
of equipment is compromised
by the operation of another
piece of equipment.
An incompatible connection can
cause accidental disconnection,
breakage, or affect the safety
function of another piece of
equipment.
Any equipment attached to
your harness (anchors, locking
connectors, absorbers etc.)
must conform to current
standards.
Contact Petzl if you are
uncertain about the
compatibility of your
equipment.
5C. Fasten and adjust the leg loops.
- NAVAHO BOD: DoubleBack buckles.
- NAVAHO BOD FAST: Fasten the FAST
buckles. Be careful of foreign bodies which
can impede the operation of the FAST
buckles (pebbles, sand, clothing...). Verify
that the buckles are correctly fastened.
5C.
DoubleBack
DoubleBack
Fast
Fast
C715003A0 (291107)
Go to size 2
Publicité
