Table des Matières
Publicité
q
e
w
q
q
w
e
w
q
Presser Foot Lifter
The presser foot lifter raises and lowers your
presser foot.
You can raise it about 0.6 cm (1/4˝) higher than the
normal up position for easy removal of the presser
foot or to help you to place heavy fabric under the
foot.
q Lowest position
w Normal up position
e Highest position
Changing Presser Foot
q Lever
w Groove
e Pin
CAUTION:
Turn OFF the power switch before changing
the foot.
• To remove
Turn the handwheel toward you to raise the
needle bar to its highest position.
Raise the presser foot.
Press the lever q on the back of the foot holder.
• To attach
Place the presser foot so that the pin e on the
foot lines up directly below the groove
foot holder. Lower the foot holder to lock the foot
in place.
To Attach and Remove the Foot Holder
CAUTION:
Turn OFF the power switch before detaching
or attaching foot holder.
q Setscrew
w Foot holder
e Presser bar
e
• To remove
Remove the thumb setscrew
counterclockwise with a screwdriver.
• To attach
Match the hole in the foot holder w with
the threaded hole in the presser bar e. Fit
the thumb screw q into the hole. Tighten
the screw q by turning it clockwise with
screwdriver.
14
of the
w
by turning it
q
Publicité
Table des Matières
