Front Panel Operation - Arcam AV860 Manuel

front panel
operation
Input
These buttons select the source
connected to the corresponding
input (or internal input)
Unused sources can be prevented
from being selected in the setup
menu by blanking the name in
MENU > Input Config.
Selects the Setup menus on the
Info
Selects the information displayed on the
lower left portion of the front panel.
OK
Used to enter selections made in the
Setup menu.
AVR850
Menu
on-screen display (OSD).
Direct
Stereo Direct on/off. Provides a direct analogue path from
the analogue inputs to the left and right front outputs.
Switches off any surround processing modes and shuts
down the DSP circuits for best stereo sound quality.
Mode
Display
Selects between Stereo
This switches the display brightness
and the available surround
between off/dim/bright.
modes for the current
source.
Zone
Selects between Zone 1 and
Zone 2 control.
Mute
Mutes all analogue audio outputs in the
currently selected zone.
Volume
Adjusts the analogue output
volume in the selected zone
(line out, speakers and
headphones).
E-19
Power/Standby LED
This indicates the status of the receiver and is
green when the Receiver is powered on. Red
indicates the unit is in Standby mode.
Phones
This socket accepts headphones with
an impedance rating between 32Ω and
600Ω, fitted with a 3.5mm stereo jack
plug.
Aux
Auxiliary line level input.
Power
Switches the main power to the
Receiver on and off.
Once the unit is switched off, it
should be left for at least ten seconds
before switching on again.
Remote control receiver. This is positioned behind
the display window, above the MENU button on the
front panel. Ensure the receiver is in a clear line of
sight from the remote control for operation. If this is
not possible, use a separate sensor connected to the
input on the rear panel.
Z1 IR