Assistance - SOMFY Dexxo Pro io Manuel D'installation

Dexxo Pro io
ATTENTION
1.5 m and within sight of the door, but away from moving
parts.
- the mechanism is correctly adjusted
- the manual back release device is operating correctly
- the motorisation changes direction when the door
encounters an object 50 mm high on the ground.
For operation in automatic mode or remote control,
photoelectric cells must be installed.
For operation in automatic mode, or if the garage door faces
a public road, an orange light type signalling device may be
required to comply with the regulations in the country in
which the motorisation is installed.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection (special glasses, gloves, ear
protection, etc.).
1.6 Regulations
SOMFY declares that this product
complies with the essential requirements of applicable
European directives.
The full text of the CE declaration of conformity is available
at the following website www.somfy.com/ce.

1.7 Assistance

installing your motorisation.
Do not hesitate to contact us; our specialists are on hand to
1.8
Risk prevention - motorisation of sectional/up and
over garage door for residential usage
Zone 4
Zone 5
Zone 3
Zone 4
3
WARNING
WARNING
Zone 2
Zone 1
Zone 3
Zone 1
Zone 4
RISK SOLUTION
ZONE 1 Obstacle detection built into
the motorisation. It must be
imperatively checked that the
between the ground
obstacle detection complies with
and the lower edge
annex A of the standard EN 12
of the door during
453.
closing
For operation with automatic
closing, install photoelectric cells
(see installation manual)
ZONE 2* Obstacle detection built into
the motorisation. It must be
imperatively checked that the
between the lintel and
obstacle detection complies with
the upper edge of the
annex A of the standard EN 12
door during closing
453.
ZONE 3* Eliminate all sticking points and
all sharp edges from the surface
of the door
trapping between the
door panels in gaps
of between 8mm and
25mm
ZONE 4* Eliminate all sharp edges on the
guide rails
between the roller rails
and bearings between the rails and the
bearings
ZONE 5* Obstacle detection built into
the motorisation. It must be
imperatively checked that the
between the
obstacle detection complies with
secondary edges and
annex A of the standard EN 12
453.
*
than 2.5 m above the ground or any other permanent
access level.
Zone 2
Zone 5
Copyright © 2015 Somfy SAS. All rights reserved